Binaseal 1000
High-strength penetrating cementitious slurry that seals concrete capillaries — also a thin-layer honeycomb repair.
Binaseal 1000
Binaseal 1000 is a two-component cementitious slurry formulated with synthetic resins and a polymeric micro-compound that penetrates the micro-capillaries in concrete. It develops high compressive strength (52 N/mm² at 28 days) and very low permeability, and doubles as a thin-layer repair mortar for concrete honeycomb. It is the rigid, high-strength counterpart to Flexseal 2000 — well suited to reservoirs, water tanks and structural surfaces where strength and a hard-wearing seal matter most.
Best for:
- Reservoirs & water tanks
- Swimming pools
- Basements & foundation slabs
- Tunnels & wall renderings
- Concrete honeycomb repair
- RC gutters & roofs
Why specify Binaseal 1000
High compressive strength (52 N/mm²)
Very low permeability
Hard-wearing & inorganic
Unaffected by UV
Non-tainting
Doubles as honeycomb repair mortar
Application method
01
Mix part A and B to a homogeneous blend with a power stirrer.
02
Pre-soak the surface (no ponding) and prime with Binaseal 1000 diluted 10–20% water.
03
Apply 2 kg/m² over 2 coats (3 coats for reservoirs & water tanks) in a criss-cross pattern; overcoat after ~24 hr.
04
Cure for 36 hours before backfilling or applying any further coatings.
The numbers, straight from the datasheet
Real manufacturer data. Download the full TDS on the downloads page.
| Components / mixing ratio | Two · 1 part A (20kg) : 1 part B (5kg) |
|---|---|
| Pot life (28°C) | 60 min |
| Drying (20°C) | Initial 3 hr · final set 4 hr |
| Compressive strength | 9 N/mm² (2d) · 52 N/mm² (28d) |
| Bending strength | 5 N/mm² (2d) · 23 N/mm² (28d) |
| Tensile strength (ASTM C-190) | 334 psi @ 28d (100% RH) |
| Flexural strength (ASTM C-190) | 470 psi @ 7d |
| Permeability | 2.7×10⁻⁸ (2 coats) · 1.9×10⁻⁸ cm/sec (3 coats) |
| Coverage | 2 kg/m² · 2 coats (3 for tanks) |
| Cure before backfill | 36 hr |
Surfaces this system protects
Trusted on real waterproofing projects
Bina-manufactured systems, applied by our own teams on roofs, tanks and structures across Malaysia.
Pools & water-retaining structures
Bina-manufactured, Bina-applied
Institutional building, sealed roof
Bina-manufactured, Bina-applied
Waterproofed institutional roof
Bina-manufactured, Bina-appliedOther Bina waterproofing systems
Bina Torchseal
Heavy-duty torch-on membrane with polyester reinforcement — for large flat roofs, decks and buried structures.
Learn more →
Bina Multiproof 5000
Cold-applied, seamless acrylic membrane with 300% elongation — flexible, recoatable, heat-reflective.
Learn more →
Bina Flexseal 2000
Two-part flexible cementitious slurry — breathable, bondable under tiles and screeds, ideal for wet areas and tanks.
Learn more →Get a quote for Binaseal 1000
Tell us your surface, area and site condition — we’ll confirm this is the right system and quote design, supply and application.